Monitoring Pipe-Wall Corrosion Rate by Ultrasonic Technique
الموضوعات : journal of Artificial Intelligence in Electrical Engineering
Behzad Esmaeili Aghdam
1
,
Hossein Nasir Aghdam
2
1 -
2 -
الکلمات المفتاحية: Ultrasonic, Pipe Corrosion, Model-Based Estimation, Signal processing,
ملخص المقالة :
thickness and corrosion/erosion rate. In this thesis, a combination of signal processing techniques are used to estimate the corrosion rate estimates based on MBE. Corrosion rate is estimated based on ultrasonic pipe wall thickness data is collected over a short period of time using MBE model. This technique is based on data collected from the speedometer applied for thinning and both indicate that they were able to estimate the rate of corrosion in short periods of time and with good accuracy.
[1] F.W. Mauldin Jr, F. Viola, W.F. Walker, (2009).
Reduction of echo de-correlation via complex
principal component filtering, Ultrasound Med.
Biol. 35 (8) (1325–1343).
[2] T. Rommetveit, T.F. Johansen, R. Johnsen, (2010). A combined approach for high resolution corrosion monitoring and temperature compensation using ultrasound, IEEE Trans. Instrum. Meas. 59 (11) 2843–2853.
[3] F. Honarvar, F. Salehi, V. Safavi, A. Mokhtari, A.
N. Sinclair, (2013). Ultrasonic monitoring of
erosion/corrosion thinning rates in industrial
piping systems, Ultrasonics 53 1251–1258.
[4] H.S. Chung, (2010). A review of CANDU feeder wall thinning, Nucl. Eng. Technol. 42 (5) 568–575.
[5] A.N. Sinclair, V. Safavi, F. Honarvar, (2011). Ultrasonic measurement of erosion/ corrosion rates in industrial piping systems, in: D.O. Thompson, D.E. Chimenti (Eds.), Review of progress in quantitative nondestructive evaluation, AIP Conf. Proc.,
[6] F. Honarvar et al., (2004). Improving the time-resolution and signal-to-noise ratio of ultrasonic NDE signals, Ultrasonics 41 (9) 755–763.
