Synthesizing and investigation on the electrochemical behavior of (Nd0.9La0.1)1.95Sr0.05Ni0.75Cu0.25O4-d and (Nd0.9La0.1)1.9Sr0.1Ni0.75Cu0.25O4-d cathode electrode for solid oxide fuel cell

Subject Areas : journal of New Materials

Hassan Shirani Faradonbeh ¹ (Department of Materials Science and Eng., Shiraz University.)
mohammad paydar ² (بخش مهندسی مواد، دانشکده مهندسی– دانشگاه شیراز، شیراز-ایران)

Received: 2017-07-22 Accepted : 2018-10-07 Published : 2018-09-23

Keywords: Electrical Conductivity, Solid Oxide Fuel Cells, Cathode, electrochemical impedance,

Abstract :

High operating temperature solid oxide fuel cells can cause damage to the cells over time, so lowering the operating temperature of solid oxide fuel cells is desirable. Although, in most cases decreasing the temperature leads to an increase of the cell components resistance, especially in the cathode. Hence, the use of cathodic materials with a good conductivity at low temperatures is interested. In this research, Ruddlesden-Popper phase, (Nd0.9La0.1)1.95Sr0.05Ni0.75Cu0.25O4-d (NLSNC0.05) and (Nd0.9La0.1)1.9Sr0.1Ni0.75Cu0.25O4-d (NLSNC0.1) has been synthesized for the first time by solid state reaction and their electrochemical performance was investigated. X-ray diffraction analysis was also performed to determine the crystalline structure of the cathode powders. Scanning electron microscopy was used to analyze the morphology of powders and microstructure of symmetric cell. Electrical conductivity of the cathode samples was measured at 300-800℃ in ambient air by DC four-probe method. Maximum total electrical conductivity of 117.65 S.cm-1 at 500℃ was obtained for NLSNC0.1. Electrochemical impedance analysis was used to measure the polarization resistance of cathodes with Sm0.2Ce0.8O1.9 (SDC) electrolyte in the symmetric cell. The lowest values of the polarization resistance for NLSNC0.05 and NLSNC0.1 compounds were 0.22 and 0.26 Ω.cm2 at 800 °C, respectively.

References:

References: 1-B. C. Steele and A. Heinzel, "Materials for fuel-cell technologies," in Materials For Sustainable Energy: A Collection of Peer-Reviewed Research and Review Articles from Nature Publishing Group, ed: World Scientific, 2011, pp. 224-231.
2 پایدار, شریعت, جوادپور, سیروس, "بهینه سازی -
پارامترهای فرآیند ریخته گری نواری زیرکونیا تثبیت
شده با ایتریا به وسیله طراحی تاگوچی به عنوان
الکترولیت پیل سوختی اکسید جامد," فصلنامه علمی-
پژوهشی مواد نوین, جلد 7 ، ش.ص 47 - 56, 2017 .
3- A. Aguadero, L. Fawcett, S. Taub ,R. Woolley, K.-T. Wu, N. Xu, et al., "Materials development for intermediate-temperature solid oxide electrochemical devices," Journal of Materials Science, vol. 47, pp. 3925-3948, 2012.
4- J. A. Kilner and M. Burriel, "Materials for intermediate-temperature solid-oxide fuel cells," Annual Review of Materials Research, vol. 44, pp. 365-393, 2014.
5- A. Orera and P. Slater, "New chemical systems for solid oxide fuel cells," Chemistry of Materials, vol. 22, pp. 675-690, 2009.
6- A. J. Jacobson, "Materials for solid oxide fuel cells," Chemistry of Materials, vol. 22, pp. 660-674, 2009.
7- J. S. Ahn, D. Pergolesi, M. A. Camaratta, H. Yoon, B. W. Lee, K. T. Lee, et al., "High-performance bilayered electrolyte intermediate temperature solid oxide fuel cells," Electrochemistry Communications, vol. 11, pp. 1504-1507, 2009.
8- C. Leon and J. Santamaria, "Defects, impurities, and transport phenomenon in oxide crystals," Epitaxial Growth of Complex Metal Oxides, p. 209, 2015.
9- S. Li, H. Tu, L. Yu, and M. T .Anwar,
11 مجله مواد نوین/ جلد 9/شماره 1/ پاییز 1397
"Fabrication and electrochemical characterizations of Nd 2 NiO 4+ δ-Ce 0.8 Gd 0.2 O 2− δ composite cathodes for anode-supported intermediate temperature solid oxide fuel cells," Electrochimica Acta, vol. 212, pp. 303-312, 2016.
10- R. K. Sharma ,M. Burriel, L. Dessemond, V. Martin, J.-M. Bassat, and E. Djurado, "An innovative architectural design to enhance the electrochemical performance of La 2 NiO 4+ δ cathodes for solid oxide fuel cell applications," Journal of Power Sources, vol. 316, pp. 128-7 , 2016 . .
11- S. Li, H. Tu, F. Li, M. T. Anwar, and L. Yu, "Investigation of Nd 2 Ni 0.9 M 0.1 O 4+ δ (M= Ni, Co, Cu, Fe, and Mn) cathodes for intermediate-temperature solid oxide fuel cell," Journal of Alloys and Compounds, vol. 694, pp. 17-23, 2017.
12- H. Shirani-Faradonbeh and M. H. Paydar, "Electrical behavior of the Ruddlesden–Popper phase,(Nd0. 9La0. 1) 2 Ni0. 75Cu0. 25O4 (NLNC) and NLNC-x wt% Sm0. 2Ce0. 8O1. 9 (SDC)(x= 10, 30 and 50), as intermediate‐temperature solid oxide fuel cells cathode ",Ceramics International, vol. 44, pp. 1971-1977, 2018.
13- G. Amow, I. Davidson, and S. Skinner, "A comparative study of the Ruddlesden-Popper series, La n+ 1 Ni n O 3n+ 1 (n= 1, 2 and 3), for solid-oxide fuel-cell cathode applications," Solid State Ionics, vol. 177, pp. 1205-1210, 2006.
14- M. Yashima, N. Sirikanda, and T. Ishihara, "Crystal structure, diffusion path, and oxygen permeability of a Pr2NiO4-based mixed conductor (Pr0. 9La0. 1) 2 (Ni0. 74Cu0. 21Ga0. 05) O4+ δ," Journal of the American Chemical Society, vol. 132, pp. 2385-2392, 2010.
15- J. Xue, A. Schulz, H. Wang, and A. Feldhoff, "The phase stability of the Ruddlesden-popper type oxide (Pr 0.9 La 0.1) 2.0 Ni 0.74 Cu 0.21 Ga 0.05 O 4+ δ in an oxidizing environment," Journal of Membrane Science, vol. 497, pp. 357-364, 2016.
16- Q. Zhou, Y. Gao, F. Wang, D. An, Y. Li, Y. Zou, et al., "Novel cobalt-free cathode material (Nd 0.9 La 0.1) 2 (Ni 0.74 Cu 0.21 Al 0.05) O 4+ δ for intermediate-temperature solid oxide fuel cells," Ceramics International, vol. 41, pp. 639-643, 2015.
17- J. Kuo, H. Anderson, and D. Sparlin, "Oxidation-reduction behavior of undoped and Sr-doped LaMnO3 nonstoichiometry and defect structure," Journal of Solid State Chemistry, vol. 83, pp. 52-60, 1989.
18-Q. Nian, L .Zhao, B. He, B. Lin, R. Peng, G. Meng, et al., "Layered SmBaCuCoO 5+ δ and SmBaCuFeO 5+ δ perovskite oxides as cathode materials for proton-conducting SOFCs," Journal of Alloys and Compounds, vol. 492, pp. 291-294, 2010.
19- H. Li, Z. Cai, Q. Li, C. Sun ,and H. Zhao, "Electrochemical investigation of Pr 2 CuO 4-based composite cathode for intermediate-temperature solid oxide fuel cells," Journal of Alloys and Compounds, vol. 688, pp. 972-977, 2016 .
20- H. Zhao, Q. Li, and L. Sun, "Ln 2 MO 4 cathode materials for solid oxide fuel cells," Science China Chemistry, vol. 54, pp. 898-910, 2011.
و ... (Nd0.9La0.1)1.95Sr0.05Ni075Cu0.25O4-d 12 سنتز و بررسی خواص الکتروشیمیایی ترکیبات
.

_||_