A New High Step-Down Converter with Lossless Passive Snubber

Subject Areas : Electronic Engineering

Elham Gerami ¹ (Department of Electrical Engineering, Isfahan (Khorasgan) Branch, Islamic Azad University, Isfahan, Iran)
Majid Delshad ² (Department of Electrical Engineering, Isfahan (Khorasgan) Branch, Islamic Azad University, Isfahan, Iran)
Mohammad Reza Amini ³ (Department of Electrical Engineering, Isfahan (Khorasgan) Branch, Islamic Azad University, Isfahan, Iran)
Mohammad Rohollah Yazdani ⁴ (Department of Electrical Engineering, Isfahan (Khorasgan) Branch, Islamic Azad University, Isfahan, Iran)

Received: 2023-02-20 Accepted : 2023-07-20 Published : 2024-02-20

Keywords: soft switching, Cascade converter, Buck converter, High Step-down,

Abstract :

In this paper, a new non-isolated soft switched DC-DC converter with high step-down conversion ratio is proposed. The proposed converter consists of two switch cells that their inputs and outputs are cascaded. This converter provides ultra-high step-down conversion ratio and due to all semiconductor devices are soft switched, switching losses are reduced, also reverse recovery losses of diodes are reduced because of ZCS turn off condition. The duty cycle of proposed converter is much larger than step-down converter and therefore does not have the problems of the converter with a narrow duty cycle and since no auxiliary switch is used to achieve soft switching, the control circuit remains simple. In this paper, the convertor operating modes are discussed and to verify the performance of the converter a 50W prototype with 100 kHz switching frequency, 100V input and 16V output is built. The converter efficiency is measured and the peak efficiency is 94% also the conducted electromagnetic interference peak in the proposed converter is reduced by 6dBµv.

References:

1. F. C. Lee and Q. Li, “High-frequency integrated point-of-load converters: Overview,” IEEE Transactions on Power Electronics, vol. 28, no. 9. 2013. doi: 10.1109/TPEL.2013.2238954.


2. A. Mallik and A. Khaligh, “A high step-down dual output non-isolated DC/DC converter,” in Conference Proceedings - IEEE Applied Power Electronics Conference and Exposition - APEC, 2017. doi: 10.1109/APEC.2017.7930700.


3. M. Saravanan and N. Ganesh, “A single-stage soft-switching LED driver based on CLCL resonant converter and BCM circuit for lighting application,” Electrical Engineering, vol. 102, no. 2, 2020, doi: 10.1007/s00202-020-00916-9.


4. R. Dayal and L. Parsa, “Non-isolated topologies for high step-down offline LED driver applications,” in Conference Proceedings - IEEE Applied Power Electronics Conference and Exposition - APEC, 2012. doi: 10.1109/APEC.2012.6165939.


5. N. Vishwanathan and V. Ramanarayanan, “A two stage power converter topology for high voltage DC power supplies under pulsed loads,” in EPE Journal (European Power Electronics and Drives Journal), 2006. doi: 10.1080/09398368.2006.11463619.


6. Y. Sahin, N. S. Ting, and I. Aksoy, “A highly efficient ZVT–ZCT PWM boost converter with direct power transfer,” Electrical Engineering, vol. 100, no. 2, 2018, doi: 10.1007/s00202-017-0546-y.


7. V. V. S. K. Bhajana, P. Drabek, and R. Thumma, “Analysis and design of a high gain non-isolated zero current switching bidirectional DC–DC converter for electric vehicles,” Automatika, vol. 60, no. 1, 2019, doi: 10.1080/00051144.2019.1578915.


8. J. Jalili, S. M. M. Mirtalaei, M. R. Mohammadi, and B. Majidi, “A ZVS high step-up converter based on an integrated boost-cuk topology,” Electrical Engineering, vol. 104, no. 2, 2022, doi: 10.1007/s00202-021-01340-3.


9. R. M. F. Neto and F. L. Tofoli, “A soft switching ZCS–ZVS double two-switch forward converter,” Electrical Engineering, vol. 100, no. 2, 2018, doi: 10.1007/s00202-017-0581-8.


10. T. Shamsi, M. Delshad, E. Adib, and M. R. Yazdani, “A New Simple-Structure Passive Lossless Snubber for DC-DC Boost Converters,” IEEE Transactions on Industrial Electronics, vol. 68, no. 3, 2021, doi: 10.1109/TIE.2020.2973906.


11. E. Gerami, M. Delshad, M. R. Amini, and M. R. Yazdani, “A new family of non-isolated PWM DC–DC converter with soft switching,” IET Power Electronics, vol. 12, no. 2, 2019, doi: 10.1049/iet-pel.2018.5351.


12. Y. Sahin and N. S. Ting, “Soft switching passive snubber cell for family of PWM DC–DC converters,” Electrical Engineering, vol. 100, no. 3, 2018, doi: 10.1007/s00202-017-0655-7.


13. M. Hajiheidari, H. Farzanehfard, and E. Adib, “High-Step-Down DC-DC Converter with Continuous Output Current Using Coupled-Inductors,” IEEE Trans Power Electron, vol. 34, no. 11, 2019, doi: 10.1109/TPEL.2019.2899951.


14. M. Amiri and H. Farzanehfard, “An interleaved nonisolated ZVS ultrahigh step-down DC-DC converter with low voltage stress,” IEEE Transactions on Industrial Electronics, vol. 66, no. 10, 2019, doi: 10.1109/TIE.2018.2886794.


15. S. P. Yang, S. J. Chen, C. M. Huang, and C. E. Chen, “A novel soft-switching high step-down forward converter,” in Proceedings - 2018 IEEE International Conference on Industrial Electronics for Sustainable Energy Systems, IESES 2018, 2018. doi: 10.1109/IESES.2018.8349854.


16. D. Cheshmdehmam, E. Adib, and H. Farzanehfard, “Soft-Switched Nonisolated High Step-Down Converter,” IEEE Transactions on Industrial Electronics, vol. 66, no. 1, 2019, doi: 10.1109/TIE.2018.2829471.


17. X. Zhao, C. S. Yeh, L. Zhang, and J. S. Lai, “A high-frequency high-step-down converter with coupled inductor for low power applications,” in Conference Proceedings - IEEE Applied Power Electronics Conference and Exposition - APEC, 2017. doi: 10.1109/APEC.2017.7931040.


18. Y. Zheng, S. Li, and K. M. Smedley, “Nonisolated High Step-Down Converter with ZVS and Low Current Ripples,” IEEE Transactions on Industrial Electronics, vol. 66, no. 2, 2019, doi: 10.1109/TIE.2018.2833047.


19. N. Mohan, Power Electronics Converters, Applications and Design 3rd. 2003.


20. I. O. Lee, S. Y. Cho, and G. W. Moon, “Interleaved buck converter having low switching losses and improved step-down conversion ratio,” IEEE Trans Power Electron, vol. 27, no. 8, 2012, doi: 10.1109/TPEL.2012.2185515.


21. A. Pressman, Switching power supply design. New York: ‎McGraw-Hill, 2009.