• صفحه اصلی
  • Investigation of Oblique Blast Loading on Trapezoidal Corrugated Core Sandwich Panels; Experimental and Numerical Study

اشتراک گذاری

آدرس مقاله


کد مقاله : JSM-2205-1741 (R1) بازدید : 135 صفحه: 109 - 119

https://doi.org/10.60664/jsm.2023.2051741

20.1001.1.20083505.2023.15.1.8.5

نوع مقاله: پژوهشی

Investigation of Oblique Blast Loading on Trapezoidal Corrugated Core Sandwich Panels; Experimental and Numerical Study

محورهای موضوعی : Applied Mechanics

H Mohammadi Hooyeh 1 (Department of Solid Mechanics, Faculty of Mechanical Engineering, University of Eyvanekey, Garmsar, Iran)
A Naddaf Oskouei 2 (Department of Solid Mechanics, Faculty of Mechanical Engineering, University of Eyvanekey, Garmsar, Iran)
Tohid Mirzababaie Mostofi 3 (Department of Solid Mechanics, Faculty of Mechanical Engineering, University of Eyvanekey, Garmsar, Iran)
Kh Vahedi 4 (Department of Solid Mechanics, Faculty of Mechanical Engineering, University of Eyvanekey, Garmsar, Iran)

تاریخ دریافت : 1401/08/17 تاریخ پذیرش : 1401/10/17 تاریخ انتشار : 1401/12/10

کلید واژه: Sandwich panels, Oblique blast loading, Coupled Eulerian Lagrangian method, Trapezoidal corrugated core,

چکیده مقاله :

In this work dynamic response of trapezoidal corrugated core sandwich panels subjected to oblique blast loading are studied both numerically and experimentally. The stand-off distance which has been determined from sandwich panel to center of the nearest face of the explosive cylinder is considered 300 mm. the experiments was performed at Four blast tube with different included angles of 0°, 15°, 30° and 45° respect to sandwich target plate. The results of numerical simulation, obtained using coupled Eulerian – Lagrangian (CEL) method at ABAQUS/Explicit software. Maximum mid- point deflection of back and front faces are compared with experiment results. The results show that with increasing angle of tilt of explosive the amount of back face deflection at angles of tilt 15°, 30° and 45° respect to the case of 0°, 4.68%, 5.86% and 9.77% decreases respectively. It is found that at the z direction, deformation profile is completely dome-shaped while the profile in the x direction is almost conical. The achieved results can be used to optimization designing of military vehicles and employed for civil infrastructure.

چکیده انگلیسی:

In this work dynamic response of trapezoidal corrugated core sandwich panels subjected to oblique blast loading are studied both numerically and experimentally. The stand-off distance which has been determined from sandwich panel to center of the nearest face of the explosive cylinder is considered 300 mm. the experiments was performed at Four blast tube with different included angles of 0°, 15°, 30° and 45° respect to sandwich target plate. The results of numerical simulation, obtained using coupled Eulerian – Lagrangian (CEL) method at ABAQUS/Explicit software. Maximum mid- point deflection of back and front faces are compared with experiment results. The results show that with increasing angle of tilt of explosive the amount of back face deflection at angles of tilt 15°, 30° and 45° respect to the case of 0°, 4.68%, 5.86% and 9.77% decreases respectively. It is found that at the z direction, deformation profile is completely dome-shaped while the profile in the x direction is almost conical. The achieved results can be used to optimization designing of military vehicles and employed for civil infrastructure.

منابع و مأخذ:


  1. Anderson Jr C.E., Behner T., Weiss C.E., 2011, Mine blast loading experiments, International Journal of Impact Engineering 38(8-9): 697-706.
    2.
  2. Gurumurthy G., 2008, Blast Mitigation Strategies for Vehicles Using Shape Optimization Methods, Thesis (S.M.) Massachusetts Institute of Technology, Computation for Design and Optimization Program.
    3.
  3. Markose A., Rao C.L., 2017, Mechanical response of V shaped plates under blast loading, Thin-Walled Structures 115:12-20.
    4.
  4. Nurick G.N., Lockley J.P., 1999, Experimental investigation to evaluate the effect of the included angle of a folded “V” shape plate for blast resistance, 1st International Conference on Integrity, Reliabaliry and Failure, Porto Portugal.
    5.
  5. Langdon G.S., Yuen S.C.K., Nurick G.N., Naidoo K., 2013, Some insights into the response of ‘shallow V shape’structures to air blast loading, Proceedings of the National Academy of Sciences of the United States of America 79(4):695-703.
    6.
  6. Li S., Li X., Wang Z., Wu G., Lu G., Zhao L., 2016, Finite element analysis of sandwich panels with stepwise graded aluminum honeycomb cores under blast loading, Composites Part A: Applied Science and Manufacturing 80:1-12.
    7.
  7. Imbalzano G., Linforth S., Ngo T.D., Lee P.V.S.,Tran P., 2018, Blast resistance of auxetic and honeycomb sandwich panels: Comparisons and parametric designs, Composite Structures 183: 242-261.
    8.
  8. Liu X., Tian X., Lu T.J., Zhou D., Liang B., 2012, Blast resistance of sandwich-walled hollow cylinders with graded metallic foam cores, Composite Structures 94(8): 2485-2493.
    9.
  9. Dharmasena K.P., Wadley H.N., Xue Z., Hutchinson J.W., 2008, Mechanical response of metallic honeycomb sandwich panel structures to high-intensity dynamic loading, International Journal of Impact Engineering 35(9):1063-1074.
    10.
  10. Qi C., Yang S., Yang L.J., Han S.H., Lu Z.H., 2014, Dynamic response and optimal design of curved metallic sandwich panels under blast loading, The Scientific World Journal 2014: 853681.
    11.
  11. Jing L., Wang Z., Zhao L., 2013, Dynamic response of cylindrical sandwich shells with metallic foam cores under blast loading—numerical simulations, Composite Structures 99: 213-223.
    12.
  12. Sun G., Zhang J., Li S., Fang J., Wang E., Li Q., 2019, Dynamic response of sandwich panel with hierarchical honeycomb cores subject to blast loading, Thin-Walled Structures 142: 499-515.
    13.
  13. Cai S., Zhang P., Dai W., Cheng Y., Liu J., 2021, Multi-objective optimization for designing metallic corrugated core sandwich panels under air blast loading, Journal of Sandwich Structures & Materials 23(4):1192-1220.
    14.
  14. Zhang P., Cheng Y., Liu J., 2014, Numerical analysis of dynamic response of corrugated core sandwich panels subjected to near-field air blast loading, Shock and Vibration 2014: 180674.
    15.
  15. Zhang P., Cheng Y., Liu J., Wang C., Hou H., Li Y., 2015, Experimental and numerical investigations on laser-welded corrugated-core sandwich panels subjected to air blast loading, Marine Structures 40: 225-246.
    16.
  16. Cheng Y., Liu M., Zhang P., Xiao W., Zhang C., Liu J., Hou H., 2018, The effects of foam filling on the dynamic response of metallic corrugated core sandwich panel under air blast loading–Experimental investigations, International Journal of Mechanical Sciences 145: 378-388.
    17.
  17. Zhang P., Cheng Y., Liu J., Li Y., Zhang C., Hou H., Wang C., 2016, Experimental study on the dynamic response of foam-filled corrugated core sandwich panels subjected to air blast loading, Composites Part B: Engineering 105: 67-81.
    18.
  18. Li S., Li X., Wang Z., Wu G., Lu G., Zhao L., 2017, Sandwich panels with layered graded aluminum honeycomb cores under blast loading, Composite Structures 173: 242-254.
    19.
  19. Zhang P., Liu J., Cheng Y., Hou H., Wang C., Li Y., 2015, Dynamic response of metallic trapezoidal corrugated-core sandwich panels subjected to air blast loading–An experimental study, Materials & Design 65: 221-230.
    20.
  20. Zhou T., Zhang P., Xiao W., Liu J., Cheng Y., 2019, Experimental investigation on the performance of PVC foam core sandwich panels under air blast loading, Composite Structures 226:111081.
    21.
  21. Yuen S.C.K., Langdon G.S., Nurick G.N., Pickering E.G., Balden V.H., 2012, Response of V-shape plates to localised blast load: Experiments and numerical simulation, International Journal of Impact Engineering 46: 97-109.
    22.
  22. Yuen S.C.K., Butler A., Bornstein H., Cholet A., 2018, The influence of orientation of blast loading on quadrangular plates, Thin-Walled Structures 131: 827-837.
    23.
  23. Markose A., Rao C.L., 2017, Mechanical response of V shaped plates under blast loading, Thin-Walled Structures 115: 12-20.
    24.
  24. Chennamsetty A.R.K., LeBlanc J., Abotula S., Parrikar P.N., Shukla A., 2015, Dynamic response of Hastelloy® X plates under oblique shocks: Experimental and numerical studies, International Journal of Impact Engineering 85: 97-109.
    25.
  25. Adhikary S.D., Chandra L.R., Christian A., Ong K.C.G., 2017, Influence of cylindrical charge orientation on the blast response of high strength concrete panels, Engineering Structures 149: 35-49.
    26.
  26. Qiu G., Henke S., Grabe J., 2011, Application of a Coupled Eulerian–Lagrangian approach on geomechanical problems involving large deformations, Computers and Geotechnics 38(1): 30-39.
    27.
  27. Hamann T., Qiu G., Grabe J., 2015, Application of a Coupled Eulerian–Lagrangian approach on pile installation problems under partially drained conditions, Computers and Geotechnics 63: 279-290.
    28.
  28. Zaidi A.M.A., Koslan F.S., Othman Z., Manar G., 2013, Appropriate coupling solvers for the numerical simulation of rolled homogeneous armor plate response subjected to blast loading, Advances in Mechanical Engineering 5: 637564.
    29.
  29. Birnbaum N.K., Francis N.J., Gerber B.I., 1999, Coupled techniques for the simulation of fluid-structure and impact problems, Computer Assisted Mechanics and Engineering Sciences 6(3/4): 295-312.
    30.
  30. Nasiri S., Sadegh-Yazdi M., Mousavi S.M., Ziya-Shamami M., Mostofi T.M., 2022, Repeated underwater explosive forming: Experimental investigation and numerical modeling based on coupled Eulerian–Lagrangian approach, Thin-Walled Structures 172:108860.
    31.
  31. Henchie T.F., Yuen S.C.K., Nurick G.N., Ranwaha N., Balden V.H., 2014, The response of circular plates to repeated uniform blast loads: An experimental and numerical study, International Journal of Impact Engineering 74: 36-45.
    32.
  32. Johnson G.R., 1983, A constitutive model and data for materials subjected to large strains, high strain rates, and high temperatures, Proceedings Seventh International Symposium on Ballistics, Hague, Netherlands.
    33.
  33. Haghgoo M., Babaei H., 2021, 2D Numerical simulation of the nonlinear deformation of thin plate under gaseous mixture detonation axisymmetric loading, Modares Mechanical Engineering 21(11): 729-742.
    34.
  34. Öztürk G., 2010, Numerical and Experimental Investigation of Perforation of ST-37 Steel Plates by Oblique Impact, Master's Thesis, Middle East Technical University.
    35.
  35. Rezasefat M., Mostofi T.M., Ozbakkaloglu T., 2019, Repeated localized impulsive loading on monolithic and multi-layered metallic plates, Thin-Walled Structures 144:106332.
    36.
  36. Rigby S.E., Knighton R., Clarke S.D., Tyas A., 2020, Reflected near-field blast pressure measurements using high speed video, Experimental Mechanics 60(7): 875-88.
    37.

سکوی نشر دانش

سند یا سکوی نشر دانش ،سامانه ای جهت مدیریت حوزه علمی و پژوهشی نشریات دانشگاه آزاد می باشد

پیوندهای سایت

مراکز مرتبط

پشتیبانی

صفحات رسمی

حقوق این وب‌سایت متعلق به سامانه مدیریت نشریات دانشگاه آزاد اسلامی است.
حق نشر © 1403-1400

صفحه اصلی| عضویت/ ورود| درباره سند| تماس با ما|
[English] [العربية] [en] [ar]