Tolerance analysis of mechanical assemblies is an important tool in reliable design of products at low cost and good quality. Using this tool, it is possible in manufacturing stage to observe the effect of parameters on assembly requirements. The direct linearization method is a useful method which runs based on vector loop analysis. In this research, the DLM method is used to analyze the tolerance chain in triggering mechanism assembly. Furthermore the percent contribution of various manufacturing dimensions on the design requirement of the assembly in determined. Manuscript profile

In this paper, the profile of surfaces machined using end mills with flat and ball end tools in modeled. The real kinematics of the tool motion, the static deflection and the run out of the tool are included in the model. The cutting forces are calculated using a semi-empirical method based on orthogonal to oblique conversion of cutting coefficients. The thickness of the uncut chip is used as the critical parameter affected by the tool run out. Based on the above model, the final profile of the surface is generated and compared with existing experimental results Manuscript profile